Armourgard SP
CCS Armourgard SP is an attractive clear, high-gloss, single pack, solvent-based coating that is both hard-wearing and smooth on a range of surfaces. Extremely durable and flexible, it provides excellent chemical and stain resistance and is easily maintained.
- Clear, non-yellowing, gloss look
- Ideal for use internally and externally
- Durable and low maintenance
- Superior resistance against chemicals and solvents
- Excellent protection from tyre marks, oil and water-based stains
1. Apply the first coat diluted 10% with CCS Armourthane Solvent of
CCS Armourgard SP at the rate of 6m2/litre in a uniform manner to
ensure adequate cover, adhesion, penetration and a smooth finish.
For smooth surfaces such as honed concrete a lamb’s wool or
mohair roller are the best application tools. When applying the
product, it is important to maintain an even wet edge with the least
amount of agitation or aeration.
2. Do not work the coating excessively or apply the coating too thickly
as this may result in air bubbles being trapped and a soft cloudy
film.
3. Allow the first coat to dry for a minimum of three to four hours
(dependant on climatic conditions) before applying the second
coat. Apply the second coat of CCS Armourgard SP at right
angles to the first coat and at the rate of 8m2/litre and allow to dry
overnight. For commercial and other high trac areas a third coat
is recommended.
Download the full product data sheet for detailed technical information, safety data, and application guidelines.
Download Data Sheet (PDF)- Clear, non-yellowing, gloss look
- Ideal for use internally and externally
- Durable and low maintenance
- Superior resistance against chemicals and solvents
- Excellent protection from tyre marks, oil and water-based stains
1. Apply the first coat diluted 10% with CCS Armourthane Solvent of
CCS Armourgard SP at the rate of 6m2/litre in a uniform manner to
ensure adequate cover, adhesion, penetration and a smooth finish.
For smooth surfaces such as honed concrete a lamb’s wool or
mohair roller are the best application tools. When applying the
product, it is important to maintain an even wet edge with the least
amount of agitation or aeration.
2. Do not work the coating excessively or apply the coating too thickly
as this may result in air bubbles being trapped and a soft cloudy
film.
3. Allow the first coat to dry for a minimum of three to four hours
(dependant on climatic conditions) before applying the second
coat. Apply the second coat of CCS Armourgard SP at right
angles to the first coat and at the rate of 8m2/litre and allow to dry
overnight. For commercial and other high trac areas a third coat
is recommended.
Download the full product data sheet.
Download PDF
